How to Use Third Party DDNS Services Hikvision An internet connected device (camera, DVR, NVR) can be configured to be accessed from outside its local network. Using an IP address allocated by the internet provider, the end user is able …
Pan and Tilt Scanner for ACTi Zoom Cameras In many surveillance applications you would wish to place a camera to cover a large area. To be able to turn your camera around and zoom in to focus your attention is …
How to Use Dynamic DNS with ACTi Cameras There are surveillance solutions that consist of single cameras scattered over a wide territory, therefore each of those cameras should be connected to Internet in order to become accessible by Control Center. …
How to use Axxon Next with Hikvision Devices AxxonSoft is one of the world’s leading producers of intelligent VMS and PSIM software. Since 2003, the company has been creating disruptive technologies that push the Safety & Security industry forward. AxxonNext …
Unable to Connect to IP Camera Guide I can not connect to the IP channel. There are following possibilities: Check the camera is online or not. Use config tool or use PC on the same network to bring up a …
How to configure Apartment VTH through Config Tool How to add DHI-VTO4202F-P-S2 to VTH via Configtool Description This article will go over the setup DHI-VTO4202F-P-S2 with Dahua Indoor Monitor by using Configtool software. Please be sure to have followed our …
How to troubleshoot P2P offline status P2P Troubleshooting Checklist P2P Enabled (Dahua Device Only) Interface Image WebUI SystemUI DHCP Enabled Interface Image WebUI SystemUI DNS 1 = 8.8.8.8 Interface Image WebUI SystemUI DNS 2 = 8.8.4.4 Interface Image WebUI SystemUI …
How to Connect IP Camera to DVR? The DVR can connect IP camera. But the IP camera should meet two requirements below. 1. The IP camera must support the ONVIF protocol. 2. The IP camera’s resolution had better equal to or lower than the …
How to Enable H.264 + Fucntion for the System? Here are the steps for you: Open the DVR’s or the NVR’s Menu click “Record” and select “Parameters“ Click and enable “H264+“, click “yes” to reboot the device, and select “apply” to save …
How to Reset the Camera to Factory Default on DVR? Purpose: For some newly released analog cameras, they have their own OSD menu. In this menu, the users could change the working mode, adjust the image parameters, and reset the camera, …
How to Connect the Small Base Station Software on Computer? Purpose: This instruction is to help you add a small base to Annke Sight software on the computer. Steps: 1. Connect the base station to the Internet. Make sure the base station …